Applies to: Saffire Pro 40, 26, 24, 24DSP, 14, Scarlett 18i20 (1st gen), 18i8 (1st gen), 6i6 (1st gen) and LS56 Saffire MixControl is the control software that is used to control the output routing and settings for the Saffire interface range. Scarlett Mix Control is the control software that is used to control the output routing and settings for the Scarlett interface range. This tutorial will explain the features and settings of MixControl to allow the greatest amount of control over your interface. The Mixer Channel Each mix allows analogue and digital inputs to be blended together with software outputs before being routed to a physical output. Each mixer channel consists of the following.

May 23, 2011 I am lost with Saffires mix control and found others are as well, please jot down your tips and tricks on it's uses, loop back recording etc, lets lear. Nov 29, 2015 Reaper & Saffire Pro40 – External Hardware Integration. Saffire Mix Control Setup. Open Saffire Mix Control. Before you make any alterations. Nokia 3110 Clock Themes here. Saffire Range. Saffire 6 USB; FireWire Saffires. Saffire PRO 40; Saffire Pro 26; Saffire PRO 24/PRO 24 DSP; Liquid Saffire 56; Saffire PRO 14. Saffire Mix Control.

Mixer channel input - This controls the input for the respective input channel.This can be a physical input or a DAW output and can be changed by clicking on the current input name. Pan control - This controls the amount of the signal sent to the left and right channels of the mix. Double-clicking on this control will centre the control and send an equal amount of the signal to the left and right channels. Fader - The controls the level of the signal in that particular mix. Graphic meter - This displays the level of the signal in dBFS before the fader. This can be a useful way to monitor the input signal.

After School Programs In Zephyrhills on this page. If the signal has clipped it will display a red bar at the top of the meter. To remedy this, lower the gain and click on the red bar. Channel mono/stereo toggle switch - This will switch the channel between one stereo channel and two stereo channels. Level meter - From left to right: Gain applied by fader (dB); Maximum level (dBFS); Current level (dBFS). PFL button - This routes only the selected channel to the monitor outputs until it is pushed again.

Solo button - This solos the selected channel in the mix. Mute button - This mutes the selected channel in the mix. Channel name - This is the name of the channel. This can be changed by clicking on it.

The Master Channel The master channel is the channel of the very right hand side of the mixer and behaves similarly to each mixer channel in the corresponding mix. The controls that differ from the mixer channel are outlined below. Mix destination - This is one of the methods to route the mix to a physical output. Clicking on this button reveals a list of possible outputs and the mix can be routed to each output by clicking on the output. Copy Mix settings - This copies the settings of the selected mix to another mix. This might be useful if a basic mix only needed to be tweaked to make it appropriate for other musicians.